Power Cord Storage; Emptying The Dirt Container; Cleaning The Filter - Bissell 2030 SERIES User Manual

Power cord storage

1. Turn Vacuum OFF (O).
2. Unplug power cord by grasping the polarized
plug, NOT the cord, and disconnect from outlet.
3. Loop power cord around cord wraps on the handle.
4. Clip molded plug to power cord to secure.

Emptying the dirt container

1. Turn Vacuum OFF (O).
2. Hold the vacuum vertically and press the
dirt container release latch. Gently pull the dirt
container from the hand vacuum.
3. Grip and remove the filter. Empty contents
into a waste container.
4. The dirt container may be rinsed with warm
water and a mild detergent if needed. The dirt
container must be thoroughly dried before
replacing.
5. Replace filter. Replace dirt container by
securely fitting onto the hand vacuum.
Make sure that the dirt container is
is correctly secured.

Cleaning the filter

The key to maximum performance is having
clean filters. Cleaning the filters after each use
will help your 3-in-1 vacuum operate at peak
cy.
Use only BISSELL replacement filters in your
BISSELL 3-in-1 vacuum.
1. Turn Vacuum OFF (O).
2. Follow the steps above to remove dirt
container and main filter. To clean the filter, shake
over a waste container until debris is gone. Place
the filter back into the dirt container.
NOTE: After heavy usage, you may clean the
filter by washing it gently by hand in warm
water and mild dish detergent. Rinse
thoroughly and make certain it is completely
dry before replacing it. If filter is torn, replace
it with a new filter.
3. Replace dirt container by securely fitting
onto the hand vacuum.
Make sure dirt container is correctly secured.
.
WARNING
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
3.
2.
2.
www.BISSELL.com
5.
3.
5