Eclipse AVN5510 Owner's Manual page 131

LhWarning
• Never cut the insulation on the power wire or use it to power any other equipment. If the rated current capacity of the power wire
is exceeded, fire and electric shocks may result.
• The wires should be secured with tape or a similar securing method to prevent any obstructions while driving. If they get wound
or entangled around components such as the steering wheel, shifting lever, or brake pedal, accidents may result.
• If removing the end of the wire to connect to another wire, be sure to wrap PVC tape or a similar wire insulating method around
the connection to insulate it. If the connection is not insulated, fire or accidents may result.
me and functions of terminals
LhCaution
• Use supplied wire harness with this main unit. Other manufacturers may use a similar wire harness connector but pin
configurations are incorrect for use with Eclipse main units and can damage the main unit. Prior to powering up the main unit,
please make sure the main unit is properly grounded with the vehicle chassis. If no ground is available to the chassis, add a
ground strap from the main unit to the vehicle chassis to improve the ground.
• Do not use with speakers having 1 to 3 ohms impedance. This main unit is designed to be used with high-powered speakers
rated above 50 W with impedance rating between 4 and 8 ohms.
o
INTERCONNECTING WIRES
(Sub-woofer, line out, speed pulse,
parking brake, reverse, video out and
steering remote control connector)
for the main unit terminals.
[2]4
o
0 0 . .
00~
[2]
0~~
r
o
INTERCONNECTING WIRES
(Power and speaker wires)
~ Tip - - - - - - - - - - - - - - - - - - . . , .
• Refer to page 7 for details on the wire colors and connection points for interconnecting wires (1), @
and @.
• Refer to page 8 for details on connection points
G)
MAIN UNIT
-6-