Normal Operation With Cac - Belkin F1DN001R User Manual

OPERATION
SECTIONS
Table of Contents

Normal operation with CAC

CAC indication appears on every channel in which CAC is enabled. To
enable or disable CAC use the front panel sliders on the Secure KVM,
as described in the Secure KVM User Manual.
CAC indication only appears on enabled channels when a CAC device
is connected to the CAC port for those channels on the Secure KVM.
The following example uses a 4-Port Secure KVM with CAC enabled on
computers 1 and 3.
• Default display after power up shows the active KVM channel is 1.
CAC is enabled on channels 1 and 3.
Channel
1 Internet
2 Secure AF
3 Classified ERP
4 Navy OP
• The CAC indicator next to the channel name flashes and then
appears highlighted, showing that CAC is mapped to this channel.
Belkin ® Secure Desktop Controller Unit (DCU) User Manual
1 2
CAC
CAC
F1DN003R
3 4
• Selecting channel 2 will move the active channel to 2 but the CAC
remains on channel 1, because CAC is not enabled on channel 2.
• Selecting channel 3 will move the active channel to 3 and the CAC
to the same channel.
Channel
1 Internet
CAC
2 Secure AF
3 Classified ERP
CAC
4 Navy OP
F1DN003R
Note: Depending on the CAC configuration on the target computer,
changing from a CAC enabled channel to a different channel, the
CAC authorization may continue indefinitely, terminate after a timeout
period, or terminate immediately.
Note: Leaving and returning to a channel that requires CAC
authentication may require re-authorization.
Caution: Terminate all CAC authorized sessions when leaving secure
computers unattended. Verify that CAC authorization is inactive and
the CAC indicator for each channel is not highlighted.
17
5 6 7
Channel
1 Internet
CAC
2 Secure AF
3 Classified ERP
CAC
4 Navy OP
BACK TO TABLE OF CONTENTS >
F1DN003R