Table of Contents
Advertisement
The chip tray directs small workpieces into a bucket when
the cut is complete. The cast iron stop allows you to
repeat cuts at the same length.
Position the chip tray, as shown in
Insert the stop rod approximately
until the end of the rod is just flush with the inside
casting surface, as shown in
Use a 4mm hex wrench to tighten the set screw
shown in
Slide the cast iron stop onto the stop rod and tighten
the set screw in the side of the stop, as shown in
.
3
⁄
" into the saw
4
.
.
.
Chip Tray
Set Screw
-15-
Chip tray installed.
Installing stop rod.
Set Screw
Cast iron stop installed.
Advertisement
Table of Contents
