Water Outlet - Whirlpool ADP8000 Instruction Manual

Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink, making sure to
avoid bending or crimping. Use the special plastic support that comes with the appliance. The free end of the hose
must be at a height between 40 and 100cm and must not be immersed in water.
PLEASE HANG UP THE DRAIN HOSE EITHER WAY OF A, B, C
Close the drain hose hook to the counter
How to Drain Excess Water From Hoses
If the sink is 1000m m higher from the flo or, the e xcess water in hoses cannot be d rained d irectly
into the sink. I t will be n ecessa ry to dra in exces s water f rom hoses into a bowl or suita ble
conta iner that is he ld outsi de and lo wer than the sink.

Water Outlet

C onne ct t he wate r drain h ose. The drain hose must be correctly fitte d to avoid water leaks.
Ensure that th e water i nlet hose is not kinked or squashed.
Extension Hose
If you nee d a drain hose extension, make sure t o use a similar drain hose .
It must be no longer th an 4 met res, otherwise the cleaning effect of the di shw asher could be reduced.
Syphon Connection
Th e waste connection must be at a height of between 50 0mm (minimum) and 1000mm (ma ximum)
from t he b otto m of the dish. The water drain hose sh ould be fixed by a ho se c lip.
The following things should be checked before starting the dishwasher.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is no leakage at the connections
4
The power cord is correctly connected
5
The power is switched on
6
The inlet and drain hoses are not knotted
7
All packing materials and printings should be taken out from the dishwasher
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
Fro nt
A
Drain pipe
Drain hose ho ok
B
C
φ 40mm
16
Co unter