Table of Contents
Advertisement
Quick reference guide
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With "Delayed start" selected
it indicates the time remaining until program start (h.00) - below 1h (0:min).
If "Fx Ey" messages appears on the display, see page 9 - chapter "What to do if...".
PROGRAM
MULTIZONE
SELECTION
Allows you to choose the
washing zones. Press this
BUTTON
button (repeatedly) to
Push "P" button
select the wash zones:
(repeatedly) until selected
program number is shown
on the display (P1...Px) -
see "Table of programs" -
next page).
- indicator lits
Whirpool is a registered trademark of Whirpool USA
POWER CLEAN
Thanks to the additional
power jets this option
provides a more intensive
and powerful wash in the
lower rack, in the specific
both racks
area. This option is
recommended for
washing pots and
only lower rack
casseroles (see page 7).
Press this button to
only upper rack
activate Power Clean
(the indicator lights up).
(including
cutlery rack)
For non Power Clean
loading to achieve best
cleaning performances
and resources
optimization, Power
Clean should be switched
off.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
TABLET SETTING
DELAYED START
BUTTON
This setting allows to
optimize the cycle
Push the button
performances according
(repeatedly) to delay the
the type of detergent
start of the program.
used. Push the Tablet
Adjustable from 1 to 24
button for 3 seconds (until
hours. With each press of
the indicator lights up)
the button, the delayed
if you are using the
start indicator increases
combined detergents in
by one hour and after
tablet (rinse aid, salt and
24 restarts from 0. Then
deteregent in 1 dose).
press the START button.
If you are using powder
The dishwasher will start
detergent or liquid
after the set time.
detergent, the Tablet
indicator on the control
panel has to be off.
SALT INDICATOR
When lit (at the end of the cycle), the
salt reservoir needs to be refilled.
START/RESUME
BUTTON
Push this button to start
the selected program: the
indicator lights up and
goes off at the end of the
program.
When the door is opened
during a washing cycle, the
cycle is temporarily
paused: the Start indicator
blinks.
To resume the cycle close
the door and push Start
button again.
Chart
5019 396 03664
CANCEL/OFF
BUTTON
Push this button to switch
off the control panel.
If pressed when a
program is running it
cancels the program
ongoing draining water for
1 minute (0:01 is shown
into the display).
If pressed when the
dishwasher is switched
off, it drains any possible
liquids from dishwasher
(1 minute process).
GB -1-
Advertisement
Table of Contents
Related Manuals for Whirlpool ADP 8693
Summary of Contents for Whirlpool ADP 8693
- Page 1 Chart Quick reference guide BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS! THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. WASH TIME DISPLAY RINSE AID INDICATOR SALT INDICATOR...
- Page 2 2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”. 3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
-
Page 3: First Time Use
First time use How to set water hardness in order to always assure the best cleaning results Water hardness should be set only - Press and hold together PROGRAM Selection and CANCEL/Off buttons for minimum 3 seconds. before the first wash or if water - The current water hardness setting will be visible on the display. -
Page 4: Daily Use
Daily check Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator Visual The rinse aid dosage can be adjusted to the detergent indicator used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). -
Page 5: How To Load The Racks
How to load the racks Cutlery rack Load cutlery with the handle into the pins. Knives or cutlery with bulky handle can be loaded with the head into the pins. How to remove cutlery rack (if available) - It could be useful to remove cutlery rack to load stem glasses in upper rack. - Page 6 How to load the racks Upper rack In the upper rack you can load glasses, cups, bowls and, in the right side of the rack, you can load the dessert dishes. Foldable flaps (A) when open help to load stemmed glasses, long tools or coffee cups. Plate holders (B) can be folded down to load bowls.
- Page 7 How to load the racks Lower rack In the lower rack plates and pots can be loaded. Vertical plate holders (E) can be When the “Half load/Multizone” option is selected the cutlery basket - F folded down to create more space to load pots. (provided in some models) can be placed in the lower rack.
-
Page 8: Maintenance And Care
Select program Overview of programs The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1). Choose program according to the attached Table of programs (page 2). Duration of the program depends on the external conditions in the apartment, temperature and pressure etc. - Page 9 What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. How the faults are shown on the display: Function number “F”x - blinking Error number “E”y - blinking...
- Page 10 What to do if... Crockery and cutlery... Possible causes... Solutions..are not perfectly clean/have food - T oo little space between dishes (incorrect - Arrange crockery so that items do not touch each other. Concave items (e.g. residues arrangement of the concave items in the rack). bowls, cups) must be arranged facing downwards in the rack.
- Page 11 What to do if... Crockery and cutlery... Possible causes... Solutions..have discoloured plastic parts - Tomato/Carrot juice. - Tomato sauce, for example, can lead to discolouring of plastic parts. Powder detergent is recommended as it allows slightly higher doses to be used for improved whitening.
- Page 12 Precautions and general recommendations 1. Packing - Before cleaning or carrying out maintenance, disconnect the mains plug and turn The packaging materials are 100% recyclable and marked with the recycling symbol off the water tap; also in the event of any malfunction. - Repairs and technical modifications must be carried out exclusively by a qualified technician.