Water Inlet Hose; Water Outlet Hose; Electrical Connection - Whirlpool DW61SL Instruction Manual

Electrical connection

The earthed plug of your machine should be connected to an earthed outlet supplied by suitable
voltage and current. If there is no earthing installation, have a competent electrician carry out an
earthing installation. In case of usage without earthing installed, our company will not be responsible
for any loss of usage that might occur.
The indoor fuse current value should be 10-16 A.

Water inlet hose

Do not use the water inlet hose of your old machine, if any. Use the new
water inlet hose supplied with your machine instead. If you are going to
connect a new or long-unused water inlet hose to your machine, run water
through it for a while before making the connection. Connect the water inlet
hose directly to the water inlet tap. The pressure supplied by the tap should
be at a minimum of 0.03 Mpa and and at a maximum of 1 Mpa. If the water
pressure is above 1 Mpa, a pressure-relief valve should be fitted inbetween.
After the connections are made, the tap should be turned on fully and
checked for water tightness.
For the safety of your machine, make sure to always turn off the water inlet
tap after each wash programme is finished.
NOTE: Aquastop water spout is used in some models. In case
of using Aquastop, a dangerous tension exists. Do not cut
Aquastop water spout. Do not let it get folded or twisted.

Water outlet hose

The water drain hose can be connected either directly to the water drain
hole or to the sink outlet spigot. Using a special bent pipe (if available), the
water can be drained directly into the sink via hooking the bent pipe over
the edge of the sink.
This connection should be at a minimum of 50 cm and and at a maximum
of 110 cm from the floor plane.
Warning: When a drain hose longer than 4 m is used, the dishes might
remain dirty. In that case, our company will not accept responsibility.
8