Rinse Aid Dispenser - Whirlpool ADP8000 Instruction Manual

Rinse Aid Dispenser

The rinse aid is released du ring the final rinse to prevent water from forming droplets on your dishes, which can leave
spots and strea ks. It also improve s drying by allow ing water to roll off the d ishes. Your dishwa sher is designed to
use liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dispenser. To fill the
dispenser, open the cap and pour the rinse aid into the dispenser until the level indicator turn s co mpletely black.
The volume of the rins e aid container is about 110ml.
Function of Rinse Aid
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, wih spot and streak free drying.
Attention!
Only use branded rinse aid for dishwashers. Never fill the rinse aid dispenser with any other substances
(e.g. Dishwasher cleaning agent, liquid detergent). This would damage the appliance.
When to Refill the Rinse Aid Dispenser
If there is no rinse-aid warning light in the control panel, you can estimate the amount from the colour
of the optical level indicator
indicator will be dark .As the rinse-aid diminishes, the size of the dark dot decreases. You should never let
the rinse aid level fall 1 / 4 full.
As the rinse aid diminishes, the size of the black dot
on the rinse aid level indicator changes, as illustrated below.
Full
3 / 4 full
1 / 2 full
1 / 4 full - Should refill to eliminate spotting
Empty
1
To open the dispenser, turn the cap to the "open" (left) arrow and lift it out.
2
Pour the rinse aid into the dispenser, being careful not to overfill.
3
Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right) arrow.
Clean u p an y rinse aid spilled while durin g filling with an absorbent cloth to avoid excessive foaming
during the n ext wash. Don't forget to replace the cap before you close the dishwasher door.
" "
located next to the cap. When the rinse-aid container is full, the whole
3