Cleaning The Filter; Cleaning The Door; Protect Against Freezing; Cleaning The Spray Arms - Whirlpool ADP8000 Instruction Manual

The entire filter assembly should be cleaned at least once a week.

Cleaning the Filter

To cle an the f ilters, use a cleaning brush. R eassemble the filter parts as shown and re-insert
t he entire assembly in the dish was her, position ing it in its seat and turn i t in clockwise direction.
The cont rol panel can be cleaned by using a lig htly dam pen ed c loth.
After cleaning , m ake sure to dry it thoroughly.
For t he exteri or, use a good appliance polish w ax.
N ever use sharp o bjects, scouring pads or harsh cleaners on any part of the dishwasher.

Cleaning The Door

Protect Against Freezing

I n ca se you li ve in regions whe re temperat ure can drop below 0 , pleas e take frost protectio n measures on the
dishwasher in winter. Every
1.Cu t off the electrical power to the dis hwa sher.
2.Turn off the wat er su pply and disconnect the water inl et hose from the water valve.
3.Drain th e w ater from the inlet hose and water valve. (Use a pan to catch the wa ter)
4.Re connect the water inl et ho se t o the water valve .
5.Re move the filter at the bottom of the tub and use a sponge to soak up water in the sum p.
If your dishwasher cannot work because of the ice,
please contact qualified a service representative.

Cleaning the Spray Arms

It is necessary to clean the spray arms regularly as hard
water chemicals can clog the spray arm jets and bearings.
To remove the upper s pray arm, screw off the nut cl ockw ise then
remove th e arm.
To remove th e low er spray arm, pull out the spray arm u pwa rd.
Wash the arm s in soapy and w arm wat er and u se a soft brush to
clean the jets. Reasse mb le them a fter rinsing t hem thoroug hly.
W hen cleaning the filters, do not knock on them. Otherw ise, the filters could be
contorted and the performance of the dishw asher could be decreased.
To clean the edge around the door, you should use only a soft warm, damp cloth.
To avoid penetration of water into the door lock and electrical components, do not
use a spray cleaner of any kind.
Clean the seals periodically with a clean damp cloth.
Never use a spray cl eaner to clean the door pane l as it m ay damage t he door lock
and electrica l components.
Abra sive ag ents or some paper t owe ls should not be used becau se o f the risk of
scratchi ng or leaving spots on th e stainless steel surface.
time a fter washing cycles, please operate as follows
℃
13
：