Honda CR125R 2006 Owner's Manual page 94

Front Suspension Adjustments
40. Clean the surfaces where the front axle shaft
and axle clamps contact each other.
41. Install the left and right side collars into the
wheel hub.
42. Insert the front axle shaft through the wheel
hub from the right side. Make sure the axle
shaft is seated firmly onto the left fork leg
clamp inner surface.
43. Tighten the axle nut (9) to the specified
torque:
65 lbf·ft (88 N·m, 9.0 kgf·m)
(9)
(9) axle nut
90
Adjustments for Competition
44. Align the brake caliper (16) and hose with
the left fork leg, making sure that the brake
hose is not twisted. An improperly routed
brake hose may rupture and cause a loss of
braking efficiency. Route the hose carefully.
45. Clean the threads of the caliper mounting
bolts (15) and brake caliper thoroughly.
46. Apply locking agent to the bolt threads.
47. Install the brake caliper on the fork slider
and tighten the caliper bolts to the specified
torque:
22 lbf·ft (30 N·m, 3.1 kgf·m)
Fit the brake caliper over the disc, taking care not
to damage the brake pads.
(15)
(15) brake caliper mounting bolts (16) brake caliper
48. Install the handlebar (4) mounting rubbers
(34), washers and handlebar holder nuts (3)
and tighten the handlebar holder nuts to the
specified torque:
32 lbf·ft (44 N·m, 4.5 kgf·m)
(3) washers/handlebar holder nuts
(4) handlebar
(34) mounting rubbers
49. Install the number plate (2) by aligning its
hole (35) with the tab (36) on the steering
stem.
(16)
(34)
(35)
(2) number plate
(35) hole
(34)
(4)
(3)
(2)
(36) tab