Honda CR125R 2006 Owner's Manual page 68

Suspension
Optional Stiffer (0.46 kgf/mm) Fork Spring
2 scribe marks


Standard oil 3.0 in
level 75 mm
[capacity] 15.5 US oz
(458 cm 3 )
Maximum oil 1.6 in Slightly stiffer as
level 41 mm it nears full
[capacity] 16.7 US oz compression.
(493 cm 3 )
Minimum oil 4.6 in Slightly softer as
level 117 mm it nears full
[capacity] 14.1 US oz compression.
(416 cm 3 )
• Be sure to check the oil level. Some oil will
be left in the fork tube when the oil is drained
and causes the oil level to be raised slightly.
• Be sure the oil level is the same in both fork
legs.
• Always use the after market syringe while
adjusting the oil level.
If it isn't used, air may get into the fork.
• If a syringe is not available, first set the oil
level somewhat lower than the normal, then
add small amounts of oil until the correct level
is obtained, measuring the level each time oil
is added.
64
Servicing Your Honda
13. Remove the lock nut and spring guide
together.

 Install the partition plate (6).
(6)
(6) partition plate
14. Install the spring guide (3) as shown.
Loosely install the lock nut (2).
(2) lock nut (3) spring guide
15. Install the fork spring, spring seat and fork
cap as described in Front Suspension Oil
Level Adjustment (page 84-91).
(2)
(3)