L2 Managed Switch
ChaCter 2
21C
Ethernet Port
211
SFP Port
13
Connection
Connection
Connect the Ethernet ports of the Switch to the network devices by RJ45 cable as the
following figure shown.
RJ45 Port
Connect the SFP port to a SFP module.
For TL-SL3428, if an SFP transceiver (purchased separately1 is installed in a slot and has
a valid link on the port, the associated RJ45 port will be disabled and cannot be used.
Note:
TL-SL3428 supports 100/1000Base-FX SFP module at full-duplex mode. When
■
using a SFP module, you need log on to the GUI of the Switch and configure the
corresponding Speed and Duplex mode on Switching→Port→Port Config page.
TL-SL3452 only supports 1000Base-X SFP module at full-duplex mode.
■
Figure 4-1
Connecting the RJ45 Port
Figure 4-2
Inserting the SFP Module
RJ45 Cable
SFP Port
SFP Module