Bridge Mode - TP-Link TL-WR700N User Manual

Figure 2-2 Hardware Installation of the TL-WR700N in Repeater Mode
1. Plug the power plug of TL-WR700N in electrical wall socket.
2. Power on the notebook(s).

Note:
It is recommended that you connect a PC/notebook to the LAN port of the Router with an Ethernet
cable, and then login the Router from the PC/notebook to set the Router in AP Repeater mode.

2.3.3 Bridge Mode

Similar to the Bridge mode, TL-WR700N in Bridge mode is also used to extend the range of
wireless signal of the existing AP or wireless router.
On this mode, the only wired port works as LAN. Computer could connect to the device by either
wired or wireless way.

Note:
The Device is equipped with Smart IP function, which would help to enable its built-in DHCP
server when it's required. For your convenience, please configure your PC or other clients to
"Obtain an IP address automatically". If you need any instructions as how to do this, please refer
to Appendix B: "Configuring the
Figure 2-3 Hardware Installation of the TL-WR700N in Bridge Mode
TL-WR700N 150Mbps Wireless N Mini Pocket Router
PC".
- 7 -