Creating A Relief (3D Cutting Mode); Removing The Cutter - Roland EGX-20 User Manual

4 Creating a Relief (3D Cutting Mode)

This section describes the basic sequence of operations for creating reliefs an other three-dimensional objects. If you want
finished results of even higher quality, also see "Using the 3D Cutting Mode" on page 40.
NOTICE
Cuttable depth is 0.05 to 7 mm (0.002 to 0.27 in.) in the 3D Cutting mode. Do not attempt cutting that exceeds
this depth.

Removing the Cutter

If a cutter is installed, then remove the cutter first.

Open the cover for the carriage.


28 4 Creating a Relief (3D Cutting Mode)
Use the included hexagonal screw-
driver to loosen the retaining screw
for the cutter holder.
The screw is attached to the cutter holder in
such a way that it can be loosened but not
detached completely. The screw is attached to
the cutter holder in such a way that it can be
loosened but not detached completely.
Grasp the top of the cutter and pull it
up and out.