Attaching The Adhesive Sheet - Roland EGX-20 User Manual

Attaching the Adhesive Sheet

You use the included adhesive sheet to secure material to engrave to the table on the EGX-20.
NOTICE
Be sure the unit is in View status when attaching the adhesive sheet.



Place the adhesive sheet on the table as shown in the figure at right, press down on it from
above, and secure it in place so that it will not peel off.
Adhesive sheet
10 1 Getting Ready
Table
There are holes at the four corners of the table.
Align the corner of the adhesive sheet with the lower-left hole.
Press the power button on the EGX-20
Carriage
to turn on the power.
The carriage moves to the right edge and
the table moves to the front, the unit goes
into View status, and the Power and View
lights light up.
Peel off the protective paper from both
sides of the adhesive sheet.
Table
Adhesive sheet