Grip/Thumb Warmer Adjusting Switch; Auxiliary Dc Jack (Fx10M53S/Fx10M62S) - Yamaha FX10B Owner's Manual

Control functions
1. Headlight beam switch "LIGHTS"
2. High beam "HI"
3. Low beam "LO"
ESU10676
Grip/thumb warmer adjusting
switch
The grip/thumb warmer adjusting switch con-
trols the electrically heated handlebar grips
and throttle lever.
1

1. Grip/thumb warmer adjusting switch

To raise the temperature
To raise the grip warmer temperature, press
the " " side of the switch. To raise the thumb
warmer temperature, press the "
the switch.
To lower the temperature
Continue to press the switch until the temper-
ature level returns to the minimum level, and
then raise the temperature to the desired lev-
el.
16
See "Fuel meter and grip/thumb warmer level
indicator" on page 13 for detailed information.
ESU10696
Auxiliary DC jack
(FX10M53S/FX10M62S)
The auxiliary DC jack is located in the front
panel and can be used for accessories.
TIP
The auxiliary DC jack can only be used if the
engine is running.
To use the auxiliary DC jack
1. Start the engine.
2. Open the auxiliary DC jack cap, and then
insert the accessory power plug into the
jack.
1. Auxiliary DC jack cap
2. Auxiliary DC jack
3. After using the auxiliary DC jack, be sure
to remove the accessory power plug from
the jack and to close the auxiliary DC jack
cap.
ECS00122
NOTICE
" side of
To avoid circuit overload and a possible
G
fuse blowing, do not use accessories re-
quiring more than the maximum rated
capacity for the auxiliary DC jack. (See
page 80 for the specified fuse amper-
age.)