Yamaha FX10B Owner's Manual page 59

1. Shroud
To install the shroud
Hook the end of the shroud onto the front cov-
er, insert the projections on the shroud into
the slots in the headlight unit stay, and then
tighten the fasteners.
Left and right side covers
To remove a side cover
1. Remove the shroud. (See above for re-
moval procedures.)
2. Loosen the fasteners, and then remove
the side cover as shown.
Periodic maintenance and adjustment
1
1
1. Fastener
2. Left side cover
To install a side cover
1. Insert the projection on the rear of the
side cover into the slot in the fuel tank
side cover and insert the projections on
the front of the side cover into the slots in
the lower cover.
1
1. Left side cover
2. Tighten the fasteners.
3. Install the shroud.
ECS00372
NOTICE
Make sure that all cables, hoses and
G
leads are routed properly before install-
ing the shroud and covers.
When installing the shroud and covers,
G
be sure to tighten the fasteners secure-
ly.
2
1
1
53