Example: Panic Button Connections - Sierra Wireless AIRLINK MP595W User Manual

Data
Rev 1.4 Draft Mar.08
Configuring the MP Modem to Report GPS and I/O
A digital input can be connected to four of the pins on the
DB15HD connector: Pins 3, 4, 11, and 12. (Pins 3 and 11 could
alternatively be used for digital output.)
Note: Before using the input/output lines, you must configure them as
inputs or outputs.
Typically a digital input device should be connected between
Ground (Pin 10) and the input port (Pin 3, 4, 11, or 12).
Figure 7-2: A button wired to Pin 4 (digital input) and Pin 10 (Ground).
The pins report a logic high on an input of 3.45 VDC. An
internal pull‐up resistor provides a high condition when the
switch is open.
The digital input pins report a logic low on an input between
0 VDC and 0.8 VDC. Sinking the input pin to ground yields a
logic low (0x00) when the port is polled.
If you configure the MP modem to send data to a network
server, digital input data can be remotely monitored.

Example: panic button connections

An I/O cable for a panic button requires a wire to one of the
digital input or I/O pins (such as #3) and one wire to the
Ground pin (#10).
59