Table of Contents
Advertisement
6: Configuring the Wireless Access
Point
• Unlock MP modem
configuration
• Enable the wireless
access point
• Set the SSID
• Configure the security
settings
• Reset the MP modem
to factory defaults
Rev 1.4 Draft Mar.08
This chapter describes how to use the MP 595 modem as a
wireless access point. You can use the MP 595W as a wireless
access point in either NAT or non‐NAT modes
Note: This chapter only applies to the MP 595W.
Overview
By default the wireless access point is disabled. The main steps
for configuring the MP modem wireless access point are:
•
Enable wireless access point.
Optional:
•
Change the password.
•
Set the SSID.
•
Set the security settings.
•
Enable NAT, if applicable. (See Chapter 5 for details.)
Note: Watcher is currently not available over a WAP network. You
can use Watcher over Ethernet or USB to enable the WAP interface,
but when the modem is using a WAP connection, Watcher is available
over Ethernet only.
If you want to use Watcher to configure the SSID and security
settings, connect the modem to the laptop via an Ethernet cable.
Once the MP modem is configured, you can remove the Ethernet
cable.
1. See
Chapter 5
for information on enabling and configuring NAT
mode.
1
.
49
Advertisement
Table of Contents
