Specifications - Extron electronics SVS 100 User Manual

Specifications — SVS 100
Video input and loopout
Number/signal type ................... 8 composite video, 4 S-video
Connectors .................................... 8 BNC female .......................... composite video
Nominal level .............................. 0.7V to 1.0V p-p
Maximum level ............................ 2.0V p-p
Impedance .................................... 75 ohms
Termination .................................. Hi Z
Vertical frequency ....................... 50 Hz to 60 Hz
Video output
Number/type/format ................ 2 composite video
Connectors .................................... 2 BNC female ......................... composite video
Nominal level .............................. 0.7V to 1.0V p-p
Impedance .................................... 75 ohms
Sync standards ............................. NTSC, PAL
Audio input
Number/type/format ................ 4 stereo, balanced/unbalanced
Connectors .................................... 4 3.5 mm, 5-conductor captive screw
Impedance .................................... Unbalanced ............................. 50 kohms, DC coupled
Maximum input level ................. +19.5dBu (balanced/unbalanced) @ stated %THD+N
Input gain adjustment ................ -15dB to +9dB, adjustable per input via RS-232 or front panel
CMRR ............................................ >75dB @ 20 Hz to 20 kHz
Audio throughput
Frequency response .................... ±0.05dB @ 20 Hz to 20 kHz
THD + noise ................................. 0.03% @ 1 kHz, 0.3% @ 20 kHz at rated maximum output drive (+19.5dBu
S/N ................................................ >90dB, output +21dBu, balanced
Adjacent input crosstalk ............ >80dB @ 1 kHz
Stereo channel separation .......... >80dB @ 1 kHz
Audio output
Number/type .............................. 1 stereo, balanced/unbalanced
Connectors .................................... 1 3.5 mm, 5-conductor captive screw
Gain ............................................... Unbalanced ............................. 0dB
Impedance .................................... 50 ohms, unbalanced; 100 ohms, balanced
Gain error ..................................... ±0.1dB channel to channel
Drive (Hi-Z) ................................. > +21dBu, balanced @ stated %THD+N
Drive (600 ohm) ........................... > +15dBu, balanced @ stated %THD+N
Control/Remote
Serial control port ....................... RS-232/RS-422, 9-pin female D connector
Baud rate and protocol ............... 9600, 8-bit, 1 stop bit, no parity
Pin configurations ....................... 2 = TX
A-6 SVS 100 Appendix
4 4-pin mini-DIN female ...... S-video
1 S-video
1 4-pin mini-DIN female ...... S-video
Balanced ................................... 25 kohms, DC coupled
input, +21dBu output, balanced/unbalanced)
Balanced ................................... +6dB
3 = RX
5 = GND