Table of Contents
Advertisement
SVS 100 Features
Four NTSC or PAL video inputs —
•
2 S-video or composite video inputs — 2 rear panel, 4-pin mini-DIN
connectors (Input 1 and Input 2) accept luminance (Y) and chrominance (C)
input. Alternately, 2 rear panel BNC connectors accept composite video
input. The video inputs can be specified through a menu system, as either
Auto, Video, or S-video. Auto will automatically select the active input. If
S-video and composite video are both input, the SVS 100 will automatically
select the S-video input.
•
2 composite video only inputs — 2 rear panel BNC connectors (Input 3 and
Input 4) accept composite video input.
Four NTSC or PAL buffered output loops —
•
2 S-video or composite buffered output loops — Input 1 and Input 2 each
output a buffered loop of the selected video input on either 4-pin mini-DIN
connectors (S-video) or BNC connectors (composite).
•
2 composite video only buffered output loops — Input 3 and Input 4 each
output a buffered loop of the composite video input on BNC connectors.
Three NTSC or PAL video outputs —
•
2 composite video outputs — Switched outputs on rear panel BNC
connectors
•
1 S-video output — Switched output on rear panel 4-pin mini-DIN connector
Four balanced/unbalanced stereo audio inputs — Four rear panel captive screw
terminals accept audio inputs. Each input's level can be individually preset.
Pre-amp output for powered speakers is provided on a 3.5 mm, 5-pole captive
screw terminal.
Seamless switching — Noise and other video glitches are eliminated by a user-
selectable assortment of cut, wipe, dissolve, and fade effects.
Genlock connection — A black burst external sync signal can be input and daisy-
chained via rear panel BNC connectors.
Picture controls — Color, tint, brightness, contrast, and top and bottom blanking
can be adjusted for each input to correct for differences between sources.
Audio breakaway — Audio and video can be switched separately by using
RS-232 control. This feature can be set through Extron's Simple Instruction
Set™ (SIS™).
RS-232/RS-422 control — A computer or other RS-232/RS-422 control device can be
used to control the SVS 100 switcher with Extron's Simple Instruction Set™
(SIS™) or the Windows-based control program.
Memory — 128 picture configurations can be stored in memory.
Versatile mounting options — The SVS 100 can be rack mounted, or it can be
mounted under a desk or table, or against a wall or the side of a desk.
Mounting brackets are included.
Any inputs must either be all NTSC or all PAL, they cannot be both.
SVS 100 Introduction
1-3
Advertisement
Table of Contents
