Table of Contents
Advertisement
Getting Started
Packing List
The following components are included in
your package:
IP DECT Gateway
IP170 DECT Desk Phone
AC Adaptor (6V, 0.5A) for Desk Phone
AC Adaptor (5V, 0.5A) for Gateway
1.5M Ethernet Cable (CAT 5)
Quick Setup Guide
Setup the base
1. Plug the adaptor (5V, 0.5A) into a power
output and connect its power plug to the
base.
2. Connect the base to a router or switch with the Ethernet cable to access the internet.
The IP address of the base is assigned dynamically by default. Make sure the router's DHCP server is on.
When the base is powered up, the amber led will be amber colored. Once the network connection is
established, the led will turn off. When the base obtains the IP address, the amber led will light up again.
Setup the desk phone
Connecting the charging cradle
1. Plug the adaptor (6V, 0.5A) into a power outlet and connect its power plug to the charging cradle.
Registration
On the base:
1. Hold down the page key on the back of the base.
2. After the button is held down for five seconds, the amber led begins blinking amber and blue. The page
key can now be released. The base is now in registration mode.
On the desk phone:
1. If the desk phone has not registered to any base, it will show "Unregistered" on idle screen.
2. Press "OK" button on the desk phone to enter the main menu.
3. Use the navigation keys to highlight the item "Settings" and then press "Select" soft key.
4. Use up/down navigation keys to highlight the item "Registration" and then press "Select" soft key.
5. Highlight the item "Base Registration" and press "Select" soft key
6. Select "BS 1" and press "Select" soft key. The desk phone will attempt to register to the base.
7. Once the registration succeeds, "Deskphone #" will display on idle screen of hand- set.
4
Advertisement
Table of Contents
