Viewing The Digital Signal Meter; Viewing The System Status - Toshiba 26HL47 Owner's Manual

Viewing the digital signal meter
You can view the digital signal meter in the ANT digital TV
input source only.
To view the digital signal meter:
1 Press M~U and open the Setup menu.
2
Highlight Installation and press
@.
3
A new set oflnstallation menu icons will appear, as shown
below. Open the Terrestrial menu, highlight Signal
Meter, and press@.
4 Press'"....... ~ to select the antenna input and digital
channel whose signal you want to check.
Note: The physical digital channel number listed in the
Signal Meter screen may not correspond to a virtual TV
channel number. Contact your local broadcasters to
obtain the RF channel numbers for your local digital
stations.
To close the screen and return to the Terrestrial
menu:
Highlight Done and press @.
To return to normal viewing:
Press
E~r
Viewing the system status
- - -
To view the system status:
1 Press M~U and open the Setup menu.
2
Highlight Installation and press @.
3
A new set oflnstallation menu icons will appear, as shown
below. Open the System Status menu, highlight
System Information, and press @.
4
Press .... ~ to scroll through the menu bar to select the
Software Version and view the related information.
To close the screen and return to the Installation
menu:
Highlight Done and press @.
To return to normal viewing:
Press
E~r
Reset Factory Defaults
To reset all settings and channels to their factory
default values:
1 Press M~U and open the Setup menu.
2
Highlight Installation and press @. A new set of
Installation menu icons will appear.
3
Open the System Status menu, highlight System
Information, and press @.
4 Press .... ~ to scroll through the menu bar to select
Factory Defaults.
5
Enter your PIN code (or 0000 if no PIN code has been set).
(continued)
33
I