Adjusting Of The Minimum Of The Top Burners - Caple Sense CR1204 Instruction Manual

Adjusting of the minimum of
the top burners
In the minimum position the flame
must have a length of about 4 mm and
must remain lit even with a quick turn
from the maximum position to that of
minimum.
The flame adjustment is done in the
following way:
Auxiliary, semi-rapid and triple-
ring burners
– Light the burner
– Set the gas valve to
– Remove the knob
– Using a screwdriver turn the screw F
until the correct setting is obtained
(fig. 3.5).
Inside crown of DuAL burner
– Light the DUAL burner
– Set the gas valve to
– Remove the knob
– Using a screwdriver turn the screw H
until the correct setting is obtained
(fig. 3.6).
Outside crowns of DuAL burner
– Light the DUAL burner
– Set the gas valve to
– Remove the knob
– Using a screwdriver turn the screw G
until the correct setting is obtained
(fig. 3.6).
Normally for LPG, tighten up the
regulation screw.
2
position
position
position
F
Fig. 3.5
G
Fig. 3.6
H