The Grand Tour
Message Waiting
To make an outgoing call to an ISDN trunk
1. Access an outside CO
line
2. Dial the number.
3. Press
Making an Outgoing Call with a Subaddress to an ISDN Trunk
Subaddress digits may be required for dialing another department, or to send a call to
equipment, such as a printer. If you need to enter subaddress digits, follow these
instructions:
1. Access an outside CO
line
2. Dial the number.
3. Press
4. Enter the subaddress.
5. Press
Message Waiting
All telephones have a standard MW/FL LED for receiving/retrieving messages left by
callers that called a [PDN] that was busy or did not answer. Telephones that own
[PhDNs] can also have up to four additional (flexible) message waiting [PhDN/MW]
buttons and LEDs. The fourth message waiting button is reserved for the Message
Center.
The MW/FL LED at the called station flashes to notify you that someone called while
you were busy on another call or away from your office. You can call the other party
back by pressing the
message waiting indications.
48
67$57
.
The dialed digits will not be sent until you press this
button or until the timer expires.
68%
.
This informs the system that the following digits are
the subaddress.
67$57
.
The dialed digits will not be sent until you press this
button or until the timer expires.
0:)/
button. Voice mail devices, as well as people, can leave
Strata DK Electronic Telephone 5/99