Installation, cont'd
Audio input and output
Before connecting audio, determine whether your audio system is unbalanced or
balanced. Then, follow the instructions and illustrations below to connect either
unbalanced audio or balanced audio.
CAUTION
Figure 2-5— Unbalanced and Balanced audio connections
Unbalanced audio
Figure 2-6 — Fastening captive screws
CAUTION
Balanced audio
CAUTION
MSG Matrix Switchers • Installation
2-6
Wiring the audio incorrectly can damage the audio output circuits.
Pay special attention to the right channel wiring. The + and – layout
differs from most other Extron products.
Unbalanced Input/Output
Tip
See Caution
Sleeve (s)
See Caution
Tip
1.
Attach the audio cable to an unbalanced input connector.
2.
Attach the other end of the audio cable to the 5-pole captive screw audio
cable connector (Extron part number 10-163-05), as shown in figure 2-5.
Fasten the captive screws inside the audio cable connector as shown in
figure 2-6.
Connect the sleeve to ground (Gnd). Connecting the sleeve to a negative
(-) terminal will damage the audio output circuits.
Slide the 5-pole captive screw audio cable connector into the audio
3.
connector of the switcher, and plug the other end of the audio cable into
an amplifier or powered speakers.
1.
Attach the audio cable to a balanced input connector.
2.
Attach the other end of the audio cable to the 5-pole captive screw audio
cable connector (Extron part number 10-163-05), as shown in figure 2-5.
Fasten the captive screws inside the audio cable connector as shown in
figure 2-6.
Connect the sleeve to ground (Gnd). Connecting the sleeve to a negative
(-) terminal will damage the audio output circuits.
3.
Slide the 5-pole captive screw audio cable connector into the audio
connector of the switcher, and plug the other end of the audio cable into
an amplifier or powered speakers.
Balanced Input/Output
Tip
Ring
Sleeve (s)
Ring
Tip