Operations; Listening To A Program Source; Operations Listening To A Program Source - Sherwood RX-5502 Operating Instructions Manual

RX-5502(G) 2007.8.17 4:33 PM 페이지 10

Operations

LISTENING TO A PROGRAM SOURCE

Before operation
∙Push the POWER switch.
.
1
In the standby mode, turn the power on.
.
2
Switch the desired speakers on.
• This unit enters the standby mode and the
STANDBY indicator lights up.
This means that the receiver is not disconnected
from the AC mains and a small amount of current is
retained to support the operation readiness.
• To switch the power off, push the POWER switch
again. Then the power is cut off and the STANDBY
indicator turns off.
• Each time the ON/STANDBY button on the front
panel, the receiver is turned on to enter the
operating mode or off to enter the standby mode.
• On the remote control, press the POWER ON
button to enter the operating mode or press the
STANDBY button to enter the standby mode.
• You can select the various combinations of speakers
depending on where the speakers C or/ and D are
installed.
• Each time the SPEAKER A/B SELECTOR button is
pressed, the speakers are switched on or off as
follows :
� A/B ~ � - / - ~
or (MAIN A/B) or (MAIN -/-) or (MAIN A/-) or (MAIN -/B)
( ) : When the ROOM2 mode is set to on.
• Each time the SPEAKER C/D SELECTOR button
is pressed, the speakers are switched on or off as
follows :
� ~ C/D � ~ - / -
or (R2 C/D) or (R2 -/-)
( ) : When the ROOM2 mode is set to on.
• When using the headphones for private listening,
switch off all the speakers installed in the main room.
�Note :
• To use ROOM2 function, you should install speakers
C or/and D in another room (ROOM2) and set the
ROOM2 mode to on. (For details, refer to
"CONNECTING SPEAKERS" on page 6 and
"ROOM2 PLAYBACK" on page 21.)
10
� A/ - ~ � - /B ~
� ~ C/ - � ~ - /D
or (R2 C/-) or (R2 -/D)