Operations; Listening To A Program Source - Sherwood RX-4209 Operating Instructions Manual

Operations

LISTENING TO A PROGRAM SOURCE

Before operation
• Push the POWER switch.
1.
In the standby mode, turn the power on.
2.
Switch the desired speakers on.
3.
Select the desired input source.
• This unit enters the standby mode and the
STANDBY indicator lights up blue. The lighting
of STANDBY indicator means that the receiver
is not disconnected from the AC mains and a
small amount of current is retained to support the
memorized contents and operation readiness.
• To switch the power off, push the POWER switch
again. Then the power is cut off and the STANDBY
indicator goes off.
• When the POWER ON button on the remote
control or the ON/STANDBY button on the front
panel is pressed, this unit is turned on to enter the
operating mode.
• In the standby mode, if an INPUT SELECTOR
button on the remote control is pressed, the unit
is turned on automatically and the desired input is
selected.
• In the operating mode, when the STANDBY button
on the remote control or ON/STANDBY button
on the front panel is pressed, then it enters the
standby mode.
• Then the corresponding speaker indication("SPK
A(or/and) B") is displayed and the sound can be
heard from the speakers connected to the selected
speaker terminals.
• When using the headphones for private listening,
press the corresponding SPEAKER button to
switch off both A and B speakers ("H" indicator
lights up).
• Each time the INPUT SELECTOR knob
is rotated, the input source changes as
follows:
Tuner CD
(Frequency display)
9
AUX2 AUX1 PHONO