Operations; Listening To A Program Source - Sherwood RX-4105 Operating Instructions Manual

Operations

LISTENING TO A PROGRAM SOURCE

.
1
Turn the power on.
¦UEach time this button is pressed, this unit is turned on
to enter the operating mode or off to enter the standby
mode.
¦ U In the standby mode, the STANDBY indicator lights up.
This means that the receiver is not disconnected from
the AC mains and a small amount of current is retained
to support the memorized contents and operation
readiness.
¦ U In the standby mode, if an INPUT SELECTOR button is
pressed, the unit is turned on automatically and the
desired input is selected.
.
2
Switch the desired speakers on.
¦ U Then the corresponding speaker indication("SPK
A(or/and) B") is displayed and the sound can be heard
from the speakers connected to the selected speaker
terminals.
¦ U When using the headphones for private listening, press
the corresponding SPEAKER button to switch off both
A and B speakers.
.
3
Select the desired input source.
Each time the FM/AM button on the front panel or the
TUNER button on the remote control is pressed, the
band is changed to AM or FM.
.
4
Operate the selected component for playback.
.
5
Adjust the volume to a comfortable listening
level.
.
6
To mute the sound.
¦ U "MUTE" lights up and flickers.
¦ U To resume the previous sound level, press this button
again.
.
7
To listen with the headphones.
¦ U Be sure to switch off both A and B speakers.
10