Operations; Listening To A Program Source - Sherwood RX-4109 Operating Instructions Manual

Operations

LISTENING TO A PROGRAM SOURCE

Before operation
Push the POWER switch.
.
1
In the standby mode, turn the power on.
.
2
Switch the desired speakers on.
• This unit enters the standby mode and the
STANDBY indicator lights up.
This means that the receiver is not disconnected
from the AC mains and a small amount of current is
retained to support the memorized contents and
operation readiness.
• To switch the power off, push the POWER switch
again. Then the power is cut off and the STANDBY
indicator goes off.
When the POWER ON button on the remote
control is pressed, this unit is turned on to enter
the operating mode.
In the standby mode, if an INPUT SELECTOR
button on the remote control or the front panel is
pressed, the unit is turned on automatically and
the desired input is selected.
In the operating mode, when the STANDBY button
on the remote control is pressed, then it enters the
standby mode.
Then the corresponding speaker indication("SPK
A(or/and) B") is displayed and the sound can be
heard from the speakers connected to the
selected speaker terminals.
When using the headphones for private listening,
press the corresponding SPEAKER button to
switch off both A and B speakers.
10