Sherwood RX-5502 Operating Instructions Manual page 13

RX-5502(G) 2007.8.17 4:33 PM 페이지 12
.
7
To listen with the headphones.
Adjusting the tone (bass and treble)
.
8
Enter the tone mode.
.
9
At the desired tone mode, adjust the tone as desired.
.
10
To listen to a program source without the tone effect.
• Be sure to switch off all the speakers installed in the
main room.
• Each time this button is pressed, the corresponding
tone mode is selected and shown for 5 seconds as
follows:
� BASS � TRBL
�Note:
• When the tone direct function is activated, the tone
mode cannot be entered and "TON DIR" flickers for
3 seconds.
• If the tone display disappears, start from the step 8
again.
• The tone (BASS and TRBL) can be adjusted within
the range of -10 ~ +10 dB.
�Notes:
• Extreme settings at high volume may damage your
speakers.
• In general, the bass and treble levels are adjusted
to 0.
• "TON DIR" is displayed, "DIRECT" lights up and the
sound that bypasses the tone circuitry will be heard.
• To cancel the tone direct function, press this button
again to display "TON CTRL", and then "DIRECT"
turns off.
12