Dimplex BF8000ST Owner's Manual
Hide thumbs
Also See for BF8000ST:
- Owner's manual (16 pages) ,
- Practical user's manual (31 pages) ,
- Service manual (16 pages)
Table of Contents
Advertisement
Quick Links
IMPORTANT SAFETY INFORMATION: Always read this manual first
before attempting to install or use this fireplace. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
To view the full line of Dimplex products, please visit
www.dimplex.com
Owner's Manual
Model
BF8000ST
7208680300R04
Advertisement
Table of Contents
Related Manuals for Dimplex BF8000ST
Summary of Contents for Dimplex BF8000ST
- Page 1 For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7208680300R04...
-
Page 2: Table Of Contents
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com... -
Page 3: Welcome & Congratulations
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty. -
Page 4: Important Instructions
Do not use in areas where dropped or damaged in any man- gasoline, paint, or flammable ner, contact Dimplex Technical liquids are used or stored. www.dimplex.com... -
Page 5: Save These Instructions
IMPORTANT INSTRUCTIONS ⑮ ⑳ Do not modify the electric Always use properly ground- fireplace. Use it only as described ed, fused and polarized outlets. in this manual. Any other use not ㉑ Disconnect all power supply recommended by the manufactur- before performing any cleaning, er may cause fire, electric shock maintenance or relocation of the... -
Page 6: Fireplace Installation
Dimensions without of fire, do not store or use gaso- trim are 26 ¼ in. (663 mm) Figure 1 27 ⅜” (695 mm) 26 ¼” (663 mm) 22 ⅞” 23 ½” 8 ¾” (580 (596 mm) (222 mm) www.dimplex.com... -
Page 7: Fireplace Assembly
Fireplace Installation wide x 22 ⅞ in. (580 mm) high remove the cardboard that x 8 ¾ in. (222 mm) deep. The protects the log set. fireplace does not require any 4. Remove the right hand side additional venting (Figure 1). trim by removing four Phillips screws at the side of the Fireplace Assembly... -
Page 8: New Wall Construction
Fireplace Installation ! IMPORTANT: If not using a Option #2: A new outlet can Dimplex mantel, the fireplace be installed inside the framing must be installed in an construction. enclosure with the following Existing Fireplace MINIMUM dimensions (Figure 1. Seal all drafts and vents... - Page 9 Fireplace Installation locate fireplace where it may Figure 4 fall into a bathtub or other water container. High temperatures may be generated under certain abnormal conditions. Do not partially or fully cover or obstruct 23 ⅛” the front of this heater. (587 mm) 26 ¾”...
-
Page 10: Operation
Turn the interior light control odor is a normal condition caused knob to increase or decrease the by the initial heating of internal brightness of the interior light. heater parts. D. Heater Thermostat Control To adjust the temperature to your www.dimplex.com... -
Page 11: Maintenance
Operation Resetting the Temperature being reset. It can be reset by switching the Main On/Off Switch Cutoff Switch to off and waiting five (5) minutes This unit is equipped with a ther- before switching the unit back on. mostat which controls the tem- CAUTION: If you need to con- perature of the room by turning tinuously reset the heater, un-... - Page 12 4. Remove the trim. 1. Remove light bracket for 5. Slide glass to right side of easier access to light bulbs. fireplace to remove (Figure 9. Unscrew bulbs counter clockwise. 6. Pull the front edge of the 10. Insert new bulbs. www.dimplex.com...
-
Page 13: Glass Cleaning
Maintenance 11. Replace the Log Set by of the fireplace to remove inserting the front edge of the (Figure 6). fireplace and push down on 6. Upper bulbs are located in the rear edge of the Ember the upper left and upper right Bed until it snaps into place corners of fireplace. -
Page 14: Warranty
Limited warranty service requires a proof defects in material and workmanship for a of purchase of the product. period of 2 years from the date of the first What Dimplex will do in the event of a www.dimplex.com... - Page 15 If Dimplex is at Dimplex’s then current rates for such unable to repair or replace such prod- services.
- Page 16 Warranty COSTS OR DAMAGES, OR IF SUCH LOSSES, COSTS, OR DAMAGES ARE FORESEEABLE. IN NO EVENT WILL DIMPLEX, OR ITS OFFICERS, DIREC- TORS, OR AGENTS BE LIABLE FOR ANY DIRECT LOSSES, COSTS, OR DAMAGES THAT EXCEED THE PUR- CHASE PRICE OF THE PRODUCT.
-
Page 17: Replacement Parts
Trim Replacement Kit ......9600260100RP Dimplex North America Limited 1367 Industrial Road Cambridge ON Canada N1R 7G8 © 2013 Dimplex North America Limited...