Installation, cont'd
Figure 2-4 — Phono audio connectors
5
Figure 2-5 — Captive screw connector wiring for audio output
CAUTION
RS-232/422 connection
6
Figure 2-6 — RS-232/422 connector
2-4
CrossPoint Plus Matrix Switchers • Installation
Tip
Sleeve
Tip (Signal)
Sleeve (Gnd)
Unbalanced Mono
Connections for audio outputs — These 3.5 mm, 5-pole captive screw
connectors output the selected unamplified, line level audio. Connect audio
devices, such as an audio amplifier or powered speakers. See figure 2-5 to
properly wire an output connector.
Tip
See caution
Sleeve
Tip
See caution
Unbalanced Output
Connect the sleeve to ground (Gnd). Connecting the sleeve to a
negative (-) terminal will damage the audio output circuits.
By default, the audio output follows the video switch. Audio breakaway,
commanded via the front panel, under RS-232/422 control, or Windows-
based control program, allows you to select from any one of the audio input
sources. See chapter 3, Operation, chapter 4, Programmer's Guide, and
chapter 5, Matrix Software for details.
Remote/RS-232/RS-422 port — Connect a host device, such as a computer or
touch panel control, to the CrossPoint Plus via this 9-pin D connector for
serial RS-232/RS-422 control (figure 2-6).
5
1
1
9
6
6
9
Female
Male
If desired, attach an MCP 1000 remote control panel master unit to the
switcher's RS-232/RS-422 connector. You can also attach an MKP 1000 remote
keypad or MCP 1000 slave unit to the MCP 1000 master unit. Refer to the
MCP 1000 Remote Control Panel User's Manual, part # 68-456-01, and the MKP
1000 User's Manual, part # 68-355-01, for details.
See chapter 4, Programmer's Guide, for definitions of the SIS commands and
chapter 5, Matrix Software, to install and use the control software.
The CrossPoint Plus Series Matrix Switchers are factory configured for
RS-232 control. To use the switcher under RS-422 control, an internal cable
must be moved. See appendix B for the procedure for shifting the cable.
Tip (Left)
Sleeve (Gnd)
Ring (Right)
Tip (Left)
Sleeve (Gnd)
Unbalanced Stereo
Tip
Ring
Sleeve (s)
Tip
Ring
Balanced Output
Pin
RS-232 Function
1
—
Not used
2
TX
Transmit data
5
3
RX
Receive data
4
—
Not used
5
Gnd
Signal ground
6
—
Not used
7
—
Not used
8
—
Not used
9
—
Not used
RS-422 Function
TX-
Transmit data (-)
TX+
Transmit data (+)
RX+
Receive data (+)
RX-
Receive data (-)
Gnd
Signal ground
—
Not used
—
Not used
—
Not used
—
Not used
Need help?
Do you have a question about the CrossPoint Plus 84HV and is the answer not in the manual?