HP 441877-00B Software And Configuration Manual page 17

5.
Copy driver installation files: Xcopy the HP Configuration and Drivers Disk to the proper location
under Adapter Device Driver folder (NT40.INS\i386\DRVLIB.NIC\CPQANC folder on the
Windows NT® server). This enables the installation program to find the same file structure as on the
Drivers disk. Be sure to use the /s /e switches on xcopy.
6.
On the Windows NT® server, prepare the Microsoft® Client Installation disk using the Windows
NT® Network Client Administrator:
a.
Prepare a system diskette (for example, DOS 6.22: format a: /s). Do not use the Windows NT®
system disk.
b.
Copy UNATTEND.TXT from \NT40.INS\i386 to the diskette as specified in item 3 above
(preferably to the root (a:\)). The best location to put this file is in the root of your install disk, but
the only requirement is to specify the full path to this file in the AUTOEXEC.BAT for the WINNT
command.
c.
Use the Windows NT® Administrative Tools (Common), start Network Client Administrator and
select Make Network Installation Startup Disk.
d.
Set "Existing Path" to use the previously installed software for MS Client or, if it is the first time,
create the shared directory on the server's hard drive, using the Windows NT® 4.0 Server CD-
ROM as a source (for example, by copying from \client on the CD-ROM to c:\client).
Choose Network Client v3.0 for MS-DOS and Windows.
e.
f.
Choose any of the Network Adapters from the list (for example, NE2000 compatible).
g.
Set Computer name, User name, Domain and Network protocol when prompted.
Select OK and wait while files are copied to the disk.
h.
i.
Copy the proper ndis2 dos driver (N100.DOS, N1000.DOS, or Q57.DOS) to this disk in the
\NET directory. N100.DOS, N1000.DOS, Q57.DOS can be found in \DOS\NDIS2\ in the HP
SoftPaq file.
j.
Modify A:\NET\SYSTEM.INI : netcard=N100.DOS (or N1000.DOS or Q57.DOS).
k.
Modify A:\NET\PROTOCOL.INI : drivername=N100$ (or N1000$ or Q57$).
l.
Add a line: CACHEFLUSH=1 just after the "drivername = N100$" line.
m.
Verify or modify A:\AUTOEXEC.BAT to have the following commands:
NET USE W: \\ServerName\NT40.INS
W:\WINNT /s:W:\ /u:a:\unattend.txt
Note that W is an example for the logical drive mapped to the share on the Windows NT®
server.
n.
Remove the invocation of setup.exe from A:\AUTOEXEC.BAT.
7.
Insert the startup disk and boot up your DOS client. After connecting to the network. do one of the
following:
Input USERID as a User name when prompted. Input password as a password when prompted.
o
Modify the NET START line in the AUTOEXEC.BAT to NET LOGON USERID PASSWORD /YES.
o
Samples and templates
PROTOCOL.INI
[network.setup]
version=0x3110
netcard=ms$ne2clone,1,MS$NE2CLONE,1
;transport=ms$ndishlp,MS$NDISHLP
Installation 17