HP 441877-00B Software And Configuration Manual page 119

This keyword is to enable the use of batching receives within a specific time period.
o
Min = 0, disabled
o
Max = 5000000, 5 seconds
o
Units are in micro seconds
o
Default = 360
o
TxPacketsPer=
This keyword is to enable the use of batching transmits to a specific amount of packets.
o
Min = 0, disabled
o
Max = 100
o
Default = 64
o
CheckSum=
This keyword is to enable or disable the transmit & receive checksum off loading feature. The
o
checksum off loading support is only for TCP/IP packets. For that reason, the default OFF.
Choices are: ON, OFF, TX, RX
o
Default is ON
o
TxFlow=
This keyword allows enabling/disabling of TxFlow control.
o
Choices are: ON, OFF
o
Default is OFF
o
RxFlow=
This keyword allows enabling/disabling of RxFlow control.
o
Choices are: ON, OFF
o
Default value is OFF
o
VLAN=
This keyword allows enabling/disabling of VLAN tagging support. This keyword is only used
o
when the QASP program is loaded for VLAN support on the Q57 driver. Do not set the VLAN
keyword to 1 if the QASP program is not being used.
Choices are: 0 (Disabled), 1 (Enabled)
o
Default value is 0
o
Jumbo=
This keyword enables Jumbo frame support. When enabled, jumbo packets of up to 9000 bytes
o
are supported.
Jumbo=1514-9000
o
Default is jumbo packets not supported.
o
PDriver=
This keyword allows for the driver to operate in persistent driver mode. Only use it if the adapter
o
is placed in a Hot Plug PCI slot and only if required to swap with an exact same board.
Choices are: ON, OFF
o
Default value is OFF
o
Adapter configurations 119