HP 441877-00B Software And Configuration Manual page 164

-firmall <file>
Updates device eeprom based on <file>; Only MAC address will be preserved
-pxe
Programs PXE firmware from file
-elog <file>
Produces a log file with only error information
-dids
Shows PCI DID, VID, SDID, and SVID of present devices
-pasf <file>
Programs ASF firmware
o
<file> is a text file that contains ASF bin file names
o
-pxes <value>
Sets PXE speed
o
Value = 0 for auto; Value = 1 for 10HD; Value = 2 for 10FD; Value = 3 for 100HD; Value = 4
o
for 100FD; Value = 6 for 1000FD (fiber)
-hlb <spd>
Sets device host loopback mode
o
spd = 10/100/1000
o
dflt = 1000
o
-tr <pkts> <spd>
Sets Tx and Rx pkts packets
o
dflt Tx pkts = 1e6
o
spd = 10/100/1000
o
-lbsped <spd>
Runs D3 loopback test at <spd>
o
spd = t/h/g => 10/100/1000
o
-l200 <m200>
Runs D4 loopback test with 200*m200 packets
-dispgbend
Runs D4 loopback test and displays packets at end
-disppkts
Runs D4loopback test and displays packet count
-errlimit <lim>
Runs D4 loopback test. Fail after errors greater than <lim>.
-pktf0
Runs D4 loopback test. Packet Data Alternating F 0.
-rsttm <x>
<x> = 0 dis GRC rst. <x>!=0, post rst dly in ms
o
Diagnostics 164