Control functions
To increase the rebound damping force, turn
the adjusting dial in direction (a). To decrease
the rebound damping force, turn the adjusting
dial in direction (b).
(b)
2
1. Rear shock absorber damping force remote
adjusting dial
2. Standard position
Rebound damping setting:
Minimum (soft):
11 click(s) in direction (b)*
Standard:
Adjusting dial aligned with standard
position match mark
Maximum (hard):
11 click(s) in direction (a)*
* With the adjusting dial in the standard
position
ESU13290
Adjusting the compression damping
force of the rear shock absorber
(RX10PXT)
The compression damping force can be ad-
justed by turning the adjusting knob.
To increase the compression damping force,
turn the adjusting knob in direction (a). To de-
crease the compression damping force, turn
the adjusting knob in direction (b). NOTICE:
Do not continue to turn the adjusting knob
in direction (a) after it stops. The shock ab-
sorber could be damaged and damping
force adjustments will not be able to be
made. Do not turn the adjusting knob in di-
rection (b) more than 12 click(s). Even if
32
1
(a)
the adjusting knob is continually turned
after 12 click(s), there will be no change in
the damping force. Be sure to stop the ad-
justing knob at a position where there is a
click.
[ECS00910]
1. Compression damping force adjusting knob
Compression damping force setting:
Minimum (soft):
12 click(s) in direction (b)*
Standard:
6 click(s) in direction (b)*
Maximum (hard):
2 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
ESU11046
Adjusting the control rods
The weight transfer can be adjusted by turn-
ing the adjuster on the control rod (RX10P /
RX10PS) or the adjusting nuts on the control
rods (RX10PXT).
RX10P / RX10PS
1.
Check the control rod length using the
scale on the special wrench as shown.
TIP
In order to obtain a precise measurement, the
special wrench corner should touch the con-
trol rod adjuster, and the locknut must be
turned so that one of its notches aligns with
the wrench allowing the wrench to fit horizon-
tally on the control rod.
(a)
(b)
1