Yamaha Apex RX10PA Owner's Manual page 37

5. To increase the air pressure, operate the
pump a few times. The pressure should
increase slowly. If the pressure increases
rapidly, check to make sure that the
pump is properly connected and tight-
ened onto the air valve. To decrease the
air pressure, push the black bleed valve
button. NOTICE: Do not exceed 1551
kPa (15.5 kgf/cm², 225 psi).
1
150
10
15
5
20
0
R ACING S HOX
bar
psi
1. Pressure gauge (high-pressure meter)
1. Bleed valve button
Air pressure range:
965–1551 kPa (9.7–15.5 kgf/cm²,
140–225 psi)
Recommended air pressure:
1138 kPa (11.4 kgf/cm², 165 psi)
TIP
To allow pressure to escape from the pump
and the shock absorber, push the button half-
way down and hold it. To allow only a small
amount of pressure to escape, push the but-
ton all the way down and quickly release it.
6.
[ECS00981]
TIP
When removing the connector, the sound of
air escaping may be heard, but this is from the
pump hose, not the shock absorber.
7.
TIP
If the shock absorber bottoms too easily or
rolls too much during cornering, increase the
air pressure by 34 kPa (0.3 kgf/cm², 5 psi). If
the shock absorber is too firm and you want a
more compliant ride, decrease the air pres-
sure by 34 kPa (0.3 kgf/cm², 5 psi).
ESU14010
Adjusting the rebound damping force
of the rear shock absorber (RX10P)
EWS00161
Do not turn the remote adjusting dial while
the snowmobile is moving as this could
cause loss of control, an accident, and in-
jury.
ECS00291
NOTICE
Be sure to stop the remote adjusting dial
at a marked position around the dial where
there is a click.
The rebound damping force can be adjusted
by turning the rear shock absorber damping
force remote adjusting dial.
Control functions
Push the hose connector lock lever
down, and then remove the hose connec-
tor from the air valve.
Install the air valve cap.
WARNING
31