Yamaha Apex RX10PA Owner's Manual page 18

Control functions
TIP
To switch the speedometer, odometer, and
G
tripmeter displays between kilometers and
miles, select the odometer mode "ODO",
and then push the "SELECT" button for at
least 10 seconds while the snowmobile is
stopped.
To switch the barometer display between
G
hectopascal "hPa" and inches of mercury
"inHg", select the barometer mode "BARO",
and then push the "SELECT" button for at
least 3 seconds while the snowmobile is
stopped.
Odometer, tripmeter, and barometer
modes
1. Odometer/tripmeter/barometer
Pushing the "SELECT" button switches the
display between the odometer mode "ODO",
tripmeter modes "TRIP A" and "TRIP B", and
barometer mode "BARO" in the following or-
der:
ODO → TRIP A → TRIP B → BARO → ODO
If the fuel level warning indicator and the
warning light come on (see page 14), the
odometer display will automatically change to
the fuel reserve tripmeter mode "F-TRIP" and
start counting the distance traveled from that
point. In that case, push the "SELECT" button
to switch the display between the various trip-
meter and odometer modes in the following
order:
12
F-TRIP → ODO → TRIP A → TRIP B →
BARO →F-TRIP
To reset a tripmeter, select it by pushing the
"SELECT" button, and then push the "RE-
SET" button for at least 1 second. If you do not
reset the fuel reserve tripmeter manually, it
will reset itself automatically, and the display
will return to the prior mode after the snowmo-
bile has been refueled and traveled 5 km (3
mi).
Oil change tripmeter
When the periodic oil change interval is
reached at the initial 800 km (500 mi), then at
every 4000 km (2500 mi) thereafter, the oil
change tripmeter and "OIL" flash alternately in
the odometer display, and the tripmeter starts
counting the distance traveled from that point.
When this occurs, change the engine oil as
soon as possible. (See page 56 for the oil
change procedure.)
1
TIP
The oil change tripmeter will flash only
G
when the snowmobile is stopped.
To return to the previous display mode,
G
push the "SELECT" button. To display the
oil change tripmeter again, turn the key to
the off position, then back to the on position.
After changing the engine oil, reset the oil
change tripmeter as follows.
E LO