Yamaha Apex RX10PA Owner's Manual page 19

To reset the oil change tripmeter (when the
engine oil was changed after the oil change
tripmeter appeared)
1. To display the oil change tripmeter, turn
the key to the on position.
2. Push the "RESET" button for at least 1
second while the oil change tripmeter and
"OIL" are flashing alternately in the odom-
eter display. The distance traveled since
the last oil change and "OIL" will flash al-
ternately in the odometer display.
3. Push the "RESET" button for approxi-
mately 3 seconds. "00000" and "OIL" will
flash alternately in the odometer display 3
times, and then the display will return to
the previous display mode.
If the engine oil is changed before the oil
change tripmeter appears in the display (i.e.,
before the periodic oil change interval has
been reached), the tripmeter must be reset af-
ter the oil change for the next periodic oil
change to be indicated at the correct time.
In that case, reset the oil change tripmeter as
follows.
To reset the oil change tripmeter (when the
engine oil was changed before the oil change
tripmeter appeared)
1. Push the "SELECT" button until "ODO" is
displayed, and then push the "RESET"
button for at least 1 second. The distance
traveled since the last oil change and
"OIL" will flash alternately in the odometer
display.
2. Push the "RESET" button for approxi-
mately 3 seconds. "00000" and "OIL" will
flash alternately in the odometer display 3
times, and then the display will return to
the previous display mode.
Control functions
Clock
To set the clock
1. Push the "SELECT" button and "RESET"
button simultaneously until the hour digits
start flashing.
1
2
1. "SELECT" button
2. "RESET" button
3. Clock
2. Push the "RESET" button to change the
hour setting, and then push the "SE-
LECT" button. The minute digits will start
flashing.
3. Push the "RESET" button to change the
minute setting, and then push the "SE-
LECT" button. The clock starts when the
"SELECT" button is released.
TIP
The clock must be set again when the battery
is disconnected.
Display brightness control
This function allows you to adjust the bright-
ness of the meter display to suit the outdoor
lighting conditions.
To adjust the display brightness
1. Turn the key to the off position.
2. Push and hold down the "SELECT" but-
ton.
3
13