Chapter 4: Power Up
Connecting the to the main electrical supply provides power to the switch.
!
VOLTAGE ALERT:
To isolate the switch completely, you must disconnect all power connections: AC
VOLTAGE ALERT:
plug or DC terminal block and DC BUPS power.
AC version
Note:
The X330STK-ML stacking module shown is an extra-cost option.
Note:
1. Insert the power cord into the power connector (BUPS or Power Supply) on the rear of the
unit.
Figure 4: AC version rear panel
Figure notes:
1. BUPS connector
2. AC connector
2. Insert the other end of the power cord into the electricity supply.
- The unit powers up and performs a self test procedure. The LEDs flash at regular
intervals after the self-test procedure is completed successfully.
2
1
Issue 1 September 2005
19