Building A Stack - Avaya P334T-ML Quick Start Manual

Before you Start

Building a stack

Follow the guidelines in this section in order to build a working stack using any combination of
the following devices:
P330 series
●
P330-ML series
●
G700
●
P330 series
●
1. Add only a single box at a time to an existing stack.
!
Important:
The stack master (also called "stack IP Agent") may fail to preserve existing
Important:
"stack configuration" if you will add more than a single device to an existing stack
at a time.
- After adding the first box, wait until the stack is functioning fully before adding the next
device.
2. Refer to
For example, if you wish to add a P332G-ML to a stack with P330 4.5 switches, the
P332G-ML switch must have firmware version 4.5.8.
- Upgrade/downgrade the firmware of switches that do not match version in the table.
Tip:
It is highly recommended to upgrade/downgrade before connecting the added
Tip:
box to an existing stack.
- Ensure switches of the same type have the same firmware version
8 Quick Start for Hardware Installation: Multilayer Stackable Switch
Table 4 to see which firmware versions can be used in mixed stacks.