Maintenance; Replacement Parts; Cleaning Motorized Floor Brush; Resetting Motor Thermostat - Shark NV70 Owner's Manual

Maintenance

Rotating
Brush
Cleaning The Motorized Floor
Brush
When your motorized floor brush
needs cleaning or locks onto an
object, it automatically shuts
down to prevent damage to your
lifetime belt. The indicator light
will illuminate red warning you
to turn off the vacuum and clear
blockage immediately. The light will
reset itself once blockage has been
cleared and power has been cycled
on/off or vacuum has been locked in
the upright position.
1
Detach the motorized floor
brush from the detachable
canister.
2
Inspect the opening underneath
and the rotating brush. If a
build-up of debris is present,
remove it. Carefully cut
anything wound around the
rotating brush with scissors.
Avoid damaging or cutting the
bristles.
12 TOLL FREE: 1-800-798-7398
NV70_26_IB_E_130228_1.indd 12
Resetting the Motor Thermostat
Your Shark Navigator™
®
DLX Vacuum is equipped with
a protective Motor Thermostat. If
the motor should overheat, the
thermostat shuts off the power.
To reset the Motor Thermostat:
Move the Power Button to the
"O" – Off position.
Unplug the vacuum.
Check for clogged hose or filter;
unclog hose and replace filter.
Refer to Checking for Blockages
on page 11.
Wait 45 minutes for vacuum to cool;
then plug in the vacuum.
Turn the Power Switch to the
"I" – On position to start the
vacuum.
Note: If vacuum still does not start,
contact Customer Service at:
1-800-798-7398.
a
Cleaning The Pet Hair Brush
1
Slide the locking latch (a)
forward and tilt the bottom
cover upward to remove.
2
Carefully remove any blockage
or debris and cut away any
build-up of hair or string
wrapped around the rotating
bristle brush with scissors.
3
To reassemble, insert the tabs
on the front edge of the bottom
cover into the matching holes
in the top half and tilt it back
down until it clicks into place.
Ordering Replacement Parts
To order additional parts and
accessories, go to
www.sharkclean.com
or call 1-800-798-7398.
PART PART NO.
Super Stretch Hose
Dusting Brush &
Crevice Tool
Foam & Felt Filters
Hepa Filter
Turbo brush
Cleaning Wand
13-02-28 1:48 PM
152FFJ
1115FC
XFF80
XHF80
143FFJ
114FFJ