Basic Settings; Measure Wheel Size; Install The Polar Bike Mount - Polar Electro CS500 User Manual

1. When the cycling computer is mounted
on a stem or handlebar, gently press
the left or right side of the cycling
computer.
2. When you hold the cycling computer in
your hand, use the trigger buttons on
the backside of the cycling computer.

Basic Settings

Before using your cycling computer for the first time, customize the basic settings. Enter as accurate data
as possible to ensure correct feedback based on your performance.
To adjust data, use SET and accept with OK. The values scroll faster if you press and hold SET.
Activate your cycling computer by pressing any button for three seconds.
START and adjust the following data:
1. : Select
Time set 12h
2. : Enter date.
Date set
3. : Select metric
Unit (kg/cm)
4. : Enter your weight.
Weight
5. : Enter your height. In LB/FT format, first enter feet then inches.
Height
6. Birthday : Enter your date of birth.
7. : Select or
Sex Male Female
8. is displayed. To change the settings, press BACK until you return to the desired setting. To
Settings DONE
accept the settings, press OK and the cycling computer goes to time mode.

Measure Wheel Size

Before you start cycling, set the wheel size of your bike into the cycling computer. For further information,
see Bike Settings (page 21).

Install the Polar Bike Mount

You can install the bike mount on the stem or on the left- or right-hand side of the handlebar.
or . With , select
24h 12h AM
or imperial
(lb/ft)
.
Basic SET
or . Enter time.
PM
units.
ENGLISH
is displayed. Press
Getting Started 7