Setting Up The Console; System Settings - Precor P10 Operating And Maintaining

Setting Up the Console

Use the System mode to configure settings in ways that
benefit your users and your facility. The System menu is
visible only to administrators and registered service
technicians. Changes made to these settings are saved to the
fitness equipment.
The System Settings categories are:



System Settings

System Setting features remain hidden from club patrons and
can only be accessed using special keypresses. To view the
System Settings, the equipment must be in the Welcome
state. The equipment is in the Welcome state when it is on,
but not actually in use. This means that there is no exercise
session, data entry, or diagnostic operation in progress.
When the equipment is in the Welcome state:


Note: On self-powered equipment, the console initializes
when you begin working out. You must maintain a minimum
rate of motion for the Welcome banner to appear.
The changes made in System Setting modes become the
default settings when the display resets to the Welcome
banner.
CAUTION: If you change the Unit of Measure display on the
treadmill, check the speed setting to verify that it is correct.
Club Parameters
Informational Display
SELECT A WORKOUT OR PRESS QUICKSTART TO
BEGIN scrolls in the text display.
On the treadmill, the belt is not moving and the lift motor
is off.
2
Chapter