7.
Connect the SAS data cable connector to the card.
NOTE: Ensure that you connect the cable according to the connector labels on the cable. The
cable does not function properly if reversed.
8.
Route the SAS data cable through the clip on the card and through the channel on the inner side of
the chassis.
9.
Attach the connector labeled "SAS A" to connector SAS A on the backplane, and attach the
connector labeled "SAS B" to connector SAS B on the backplane.
10. Close the clamp.
11. Install the NDC riser.
12. Close the system.
13. Reconnect the system to its electrical outlet and turn the system on, including any attached
peripherals.
Cabling The PERC H730P Card
This section provides information about cabling the PERC H730P card on the the Dell PowerEdge R920
systems.
Figure 3. Cabling Diagram–2.5 Inch (x4) SAS/SATA Backplane with PERC H730P Card
1.
SAS cable connector on the PERC H730P card 2.
30
PERC H730P card