Serial And Infrared Communications Problems - HP OmniBook 5000 User Manual

reliable operation. In Control Panel, use the Enhanced icon, then choose Virtual
Memory and Change. (Drive C compression, removable-disk compression, and 32-
bit file access should not be active at the same time.)
If you want to use Microsoft DriveSpace compression on removable disks without
compressing drive C, use the following steps:
To turn on DriveSpace for only removable drives:
1. Exit Windows.
2. Type dscopy and press
3. Press
CTRL+ALT+DEL
To turn off DriveSpace:
1. Exit Windows.
2. Type dsdel and press
3. Press
CTRL+ALT+DEL
If Stacker compression software isn't working properly
If you choose to install Stacker for an HP flash disk, use these steps:
1. Insert the flash disk.
2. Use Notepad or other text editor to open the SINSTALL.BAT file on the flash
disk.
3. Insert this new line just after the DETECT line
GOTO HPOBPL
then save the change.
4. Run SINSTALL from the flash disk—then do the steps below.
Check CONFIG.SYS for the proper Stacker setup—otherwise, the card slots may
not function properly. Do the following after you install Stacker:
1. Delete the WEAR.EXE program from the flash disk—WEAR can accidentally
corrupt the data on the disk or damage the disk.
2. Use SysEdit or a text editor to open the C:\CONFIG.SYS file.
3. Make sure the Stacker line specifies drives that match your card slots—edit the
line as required. For example, the following line specifies your normal card slot
configuration:
device=c:\stacker\stacker.com /p=0 d: e:
4. Make sure the Stacker line comes before the DRVSPACE.SYS or
DBLSPACE.SYS line if present and before the Pacific Rim line ( prspf.sys )
if present.
5. If you make any changes, save them and reboot the OmniBook.
If you get unwanted messages about unrecognized PCMCIA cards
You can suppress warnings about PCMCIA cards that aren't configured properly
when you insert them. Use SysEdit or a text editor to open the CONFIG.SYS file,
find the OBMGM.COM line and add a space and -c at the end.

Serial and Infrared Communications Problems

See the Windows Quick Start manual for general information about setting up serial
ports. On the OmniBook, the serial port, infrared port, and certain PCMCIA I/O cards
are all "serial" ports.
.
ENTER
.
.
ENTER
.
84