Table of Contents
Advertisement
47160 rev3_Layout 1 02/09/2011 13:57 Page 9
Troubleshooting
Espresso coffee
Problem
•
Water is dispensing from the
Steam Wand
•
The coffee temperature is too
cold
•
The coffee grinds are wet after
use
•
Espresso is weak
•
Milk is not frothing
•
Coffee is too strong or weak
•
Indicator light is flashing
quickly
Filter coffee
Problem
•
Coffee is not brewing
Reason
•
Steam Control is open
•
Heater block is not hot enough
before dispensing
•
Coffee is not compact enough
•
Wrong coffee type
•
Air and steam are not getting
into the milk
•
Wrong volume of coffee
•
There is not enough water in
the water tank
•
The Steam Control is set to
steam
•
Air lock in pipe
Reason
•
Lid is not fully closed
•
The filter is not correctly
located
•
No water in tank
•
The glass jug is not correctly
located
Solution
•
Rotate the Steam Control so
its closed
•
Before dispensing Coffee,
make sure the ready light is
illuminated
•
Tamp the coffee before
inserting
•
Always use espresso coffee
grinds
•
Use a pin to clean the Steam
Wand nozzle and air holes in
the cleaner
•
Use the correct amount:
1 person - 7g (1-level Tamping
Spoon)
2 person 14g (2-level Tamping
Spoon)
•
Fill the water tank
•
Turn the Steam Control to the
off position
•
Switch to dispense from Steam
Wand to remove blockage
(ensure cup is placed
underneath)
Solution
•
Close the lid to start the
brewing process
•
Ensure the filter is in the
correct position
•
Fill the water tank with the
required amount of water
•
Ensure the glass jug is in the
correct position
9
Advertisement
Table of Contents
