Table of Contents
Advertisement
47160 rev3_Layout 1 02/09/2011 13:57 Page 6
Using the Steam Wand
to dispense hot water
Follow steps 1,2,3 of 'Making espresso coffee'
on Page 3. Then refer to the following.
Before first use
•
Take your coffee maker out of the box and remove
the packaging.
•
Wash the detachable parts of the machine in
warm soapy water.
•
The first time you use your coffee maker, operate
the coffee maker with water only.
•
Occasionally air locks can be present before first
use. Please refer to troubleshooting guide
(page 9) to resolve.
Adjusting the espresso
memory function
The coffee maker can dispense two different
amounts of coffee. The coffee maker comes with
the following amounts set as the default settings.
One Cup - 50ml
Two Cup - 100ml
6
Slide the On/Off Switch
Espresso Temperature Indicator Light
stop flashing when the coffee maker is ready.
5
When done, turn the Steam Control to Off
BEFORE removing the mug from underneath
the Steam Wand.
You can adjust these amounts for your own
personal preference by following these steps, (Up
to a maximum of 150ml for One Cup and 250ml
for Two Cup.)
Set up the coffee maker as normal following
1
steps 1-6 of 'Making espresso coffee' on page 3.
Then refer to the following.
Slide and hold the Espresso One Cup
2
Cup
(7)
Switch and keep pressed until the coffee
maker has dispensed the desired amount of
coffee.
Release the switch to set the new dispensing
3
amount.
The new setting will be stored even if the coffee
maker is unplugged from the mains.
It is not possible to reset the amount back to the
original dispense amount. To adjust the amount
of coffee dispensed, repeat the adjustment
process again to create a new dispense amount.
4
(10)
to On. The
(9)
will
6
(6)
or Two
Advertisement
Table of Contents
