Adjusting The Height Of The Drip Tray; Emptying The Drip Tray; Care And Cleaning - Morphy Richards ELIPTA 47160 Instructions Manual

Espresso and filter combination
Table of Contents

Advertisement

47160 rev3_Layout 1 02/09/2011 13:57 Page 7
Temperature Indicator light
The Temperature Indicator Light
when the boiler is heating, this is normal.
The Temperature Indicator Light will flash fast and
the coffee maker will not work when there is a
problem. If this occurs check;
The water tank is full and correctly installed.
The steam control is set to off.
Any air locks have been removed.
Sleep mode
Please note your coffee maker has a sleep mode
to save energy. If your coffee maker is not used
for 8 minutes, your coffee maker will enter sleep
mode. The Temperature Indicator Light
slowly in this mode.
To wake the machine, slide and release either the
one
(6)
or two cup
Using the correct type of
coffee grinds
When making espresso coffee it is important to
use the correct type of coffee grinds. Espresso
coffee is a very fine grind which is designed to
work with espresso filters. Using other types of
coffee in an espresso filter (such as filter coffee
grinds,) will result in a poorer tasting coffee and
could clog the filter.
Likewise when making filter coffee you should
use filter coffee grinds to achieve the best
results. Using espresso grinds can cause the filter
to clog and overflow.
E.S.E. Pods
The coffee maker is compatible with both E.S.E.
pods (a compact coffee pod with a paper filter
covering,) as well as ground espresso coffee.
When making espresso with an E.S.E. pod, use
the One Cup/ E.S.E Pod Filter (26).
(9)
flashes slowly
(9)
flashes
(7)
switch.
Adjusting the height of the
Drip Tray
You can adjust the height of the Drip Tray to
reduce splashing when dispensing coffee into
smaller cups such as espresso cups.
Press the two Drip Tray Adjustment Buttons
to release the spring catch and raise or lower the
drip tray.

Emptying the Drip Tray

When the water in the Drip Tray is full, the Empty
Drip Tray Level Indicator
(16)
Remove the Drip Tray
(11)
1
empty.
Clean the Drip Tray with a damp cloth before
2
replacing.

Care and cleaning

Disconnect the appliance from the mains supply.
1
Make sure the appliance has completely cooled
2
down.
Simply wipe the Steam Wand
3
a clean, damp cloth.
Do not use any abrasives or metal scourers as
this will damage the finish on the unit.
The Espresso Filter Holder
4
Water Tank
(13)
should be washed after each use
by rinsing them under water. To assist in keeping
(15)
will change colour.
from the appliance and
(2)
and exterior with
(24)
and Espresso
7

Advertisement

Table of Contents
loading

Table of Contents